SELF BUILDING WITH “THE SIPCRETE SYSTEM“ By Boris Defranceschi – Cyprus”

self builder

SIPCRETE BUILDING SYSTEM

He had no previous building experience!

He Made Panels, Erected Them, and Sprayed The Concrete,

Boris is now the Sipcrete Licensee in Cyprus
Panels are light weight, so no heavy lifting equipment is required.

Panels are light weight, so no heavy lifting equipment is required

  cretehse .jpg (14576 bytes)

The “Sipcrete” Thermocore panels are attached to the slab foundation on rebar or channel section mesh strips that are cast into the foundations or fixed with Hilti nails so each panel is continuously fixed to the base/slab.

They are so simple to assemble, only unskilled labour is required  

To attach panels to  each other a special connection and aperture closure system is used to ensure thermal bridging does not occur at window and door openings. To connect the mesh simply  joint and secure it with wire ties or a pneumatic fastening tool. 

mono1.jpg (30861 bytes)
Water penetration across the wall or roof is impossible  
   

Wiring conduit and plumbing are clipped to the steel mesh.The Thermocore Panels are easily cut to prepare apertures for windows and doors. 

mono7.jpg (41029 bytes)
Installation of electrics and plumbing is easy simply clip conduits to mesh
   

The Thermocore walls/roofs are then spray coated both inside and outside the building with 40-50 mm of 

The “Sipcrete” Concrete Finish.

Coloured and textured finishes are easily applied

Concrete facing easily applied by hand, low cost, sprayer or high out put equipment